Baumatic PG2SS Manuál s instrukcemi stáhnout pdf (Strana 14)

INSTALLATION INSTRUCTIONS

MAINTENANCE

During the guarantee period, in case of need all service intervention should be referred

back to the Baumatic Ltd Service department. Please note that intervention or repair by

any unauthorised personnel will invalidate such guarantee,

Before carrying out any maintenance, disconnect the appliance from the gas and electricity

supplies.

If a gas tap becomes stiff to operate, proceed as follows:

x Remove the control knobs, pan supports, burners and hob fixing screws & clamps.

x Remove the Hob from the worktop and remove any underside protective covers.

x Disconnect the fixings holding the tap to the fascia panel, separate the assembly, then clean

the cone and seating with a cloth dampened with solvent.

x Lightly smear the cone with high temperature grease, reassemble into position and rotate a

few times. Remove the cone again and remove any excess grease making sure that the gas

ducts are not obstructed with grease.

x Carefully reassemble the components and check for gas soundness.

If it becomes necessary to replace the gas tap, proceed as follows:

x Disconnect the appliance as described above.

x Disconnect the gas pipe from the gas tap, disassemble from the gas rail by removing the

fixing screws.

x When fitting a new tap, ensure that a new gasket is used.

x Re-connect the gas tap, check for gas soundness and reassemble the hob.

TECHNICAL DATA

ELECTRICAL DETAILS

Rated Voltage 230V ac 50Hz

Supply Connection 13A (double pole switched fused outlet with 3mm contact gap)

Power Input 0.008 to 0.02kW (depending on model)

Mains supply lead 3 x 0.75mm2 Type RR-F HAR! marked

GAS DETAILS

Connection Rp ½ (ISO R7)

Type Natural Gas (20.9 mbar) – alternative LPG G30 (28-30 mbar)

[Town Gas G110 – 120 (8 mbar) to order]

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Žádné komentáře

Baumatic PG2SS Manuál s instrukcemi Strana 14