Baumatic BT7.3BGL Uživatelský manuál

waeady BT7.3GL/BT7.3BGL 70 cm Glass chimney hood

Cleaning your Baumatic cooker hood IMPORTANT: BEFORE CLEANING, ALWAYS ENSURE THAT YOU HAVE SWITCHED YOUR COOKER HOOD OFF AT THE OMNI-POLAR SWITCH, SE

Maintenance Removing and cleaning the grease filter o First remove the grease filter by pulling down on the handle, and then pull it upwards away

Changing a light bulb IMPORTANT: BEFORE ATTEMPTING TO CHANGE A LIGHT BULB, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR MAINS

Fitting the carbon filter If the appliance is going to be used in recirculation mode then it is necessary to fit carbon filters. This will help to ab

Installation IMPORTANT: Before installation and usage read all the instructions and make sure that the voltage (V) and the frequency (Hz) indicated o

o As the colours of the wires in the appliance’s mains lead may not correspond with the coloured markings identifying the terminals in your spur box,

o Rawl plugs are provided to secure the hood to most types of walls and ceilings. However a qualified technician must verify the suitability of the m

2) Position the hood against the wall that you are intending to install it on and mark the position of the support holes that are to

4) Insert rawl plugs into all of the holes that you have drilled. 5) Fasten the support screws halfway in, leaving them 10 mm out of the

Connecting to external ducting 8) Connect the coupling to the top of the cooker hood, and then connect a 125 mm ducting hose to the coupling (please

User Manual for your Baumatic BT7.3GL/BT7.3BGL Cooker Hood 70 cm Glass chimney hood NOTE: This User Instruction Manual contains impo

200) o Mark the side measurements of both sides of chimney section D 1) Take the fixing bracket (E) and place it between the two p

12) Using an 8 mm drill bit, drill out two holes on the pencil markings that you made in step 11. Insert rawl plugs into the holes and

Completing the installation If you are setting the appliance to recirculation mode, then you should now fit the two carbon filters. See the “Fitting

Troubleshooting IMPORTANT: If your cooker hood appears not to be operating properly, before contacting the Baumatic Service Department, please refer

IMPORTANT: If your appliance appears not to be operating correctly, then you should disconnect it from your mains supply and then contact the Baumatic

25 United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 690

26

27

28 28

3Contents Page Environmental note 4 IMPORTANT SAFETY INFORMATION 5 – 7 Specifications of your cooker hood 8 Using your Bau

ENVIRONMENTAL NOTE Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useles

IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before att

o The edges of the cooker hood are sharp – be mindful of this as you handle your appliance, especially during installation and cleaning. DO NOT CLEAN

o Remember that when in extraction mode, your cooker hood is removing air from your room. Ensure that proper ventilation measures are being observed

Specifications of your cooker hood Congratulations on purchasing a Baumatic Cooker Hood! DIMENSIONS: Width (canopy): 700 mm Depth (canopy):

To use your cooker hood o Make sure that it has been installed by a suitably qualified person, as per the information contained in Baumatic’s insta